Introduction
Tools
Connectors
L i f e W i t h P e a r l . c o m
Lynden
Installation
Thank you for purchasing an authentic Pearl® faucet. The faucet you have
purchased is crafted out of the highest quality nickel, brass and stainless
steel. Each and every faucet was tested and carefully inspected by hand
before delivering to our retailers.
Please read the instructions carefully to prevent any malfunction and
damages to your plumbing and property.
Installation
Installation
The tools below are required to complete the installation. Some may not be
needed depending on the model of the faucet that you are installing. For
additional information, check with your local hardware store on the
requirements for your installation.
Below are three different types of water supply line connectors that you may
have in your house. If you encounter a different type of connection that is
not listed below, please consult your local hardware store for more
information.
3/8”
O.D. Copper Tubing
With Bullnose Risers
O.D. Copper Tubing
Without Risers
3/8”
IPS Faucet Connectors
1.
Turn off all water supply lines
and drainage lines.
2.
Attach cold and hot water
supply to the corresponding
connectors with pipe tape.
3.
The contractor will then put
the finished wall on. They will need
to make sure that the holes are small
enough for the trim plates to cover
the holes. The Spout hole should be
smaller than 1-3/4". The handle hole
should be smaller than 2".
4.
Place the trim cap then fix the
handle with the direction as showed
in the picture
5.
Tighten the spout with screw.
6.
After installing faucet, remove
aerator assembly and open the hot
and cold water supplies. Check for
leaks.Turn on faucet handle for one
minute to flush debris from faucet.
Close the handles and re-assemble
the aerator
1.
Take both the left and right
handles.
2.
Remove the top cap.
3.
Using a Philip screwdriver,
undo the screw on top of each
handle. The top handle will come off
of the cartridge base. Unscrew to
the cover plate.
4.
From the bottom, insert the
cartridge base up through the
counter.
5.
Connect the counter plate to
the top side of the cartridge.
6.
Attach the handle.
7.
Using the screw and Philips
screwdriver, attach the screw back through
the handle.
8.
Repeat these step for the other
handle.
9-10. Take the spout and remove the nut
and gaskets.
11-12. Place the spout into the counter.
Philips Screwdriver
Adjustable Wrench
The 3 holes required for this faucet should be no larger than 1-3/8"
Plumber’s Putty
Thread Seal Tape
Pliers