Peak IPEH-002210, Руководство пользователя

Страница: 17 / 37

PCAN-Router – User Manual
17
For a firmware upload via CAN the PCAN-Router is identified by
a 4-bit ID which is determined by solder bridges. A bit is set (1)
when the corresponding solder jumper position is open (default
setting: ID 15, all positions open).
Position 0 1 2 3
Binary Digit 0001 0010 0100 1000
Decimal Equivalent 1 2 4 8
4.4 Supply Voltage of External Devices
(IPEH-002210/-11)
External devices with low power consumption (e.g. bus converters)
can be supplied via the CAN connection CAN1 and CAN2. With a
solder bridge for each CAN channel on the board of the PCAN-
Router a voltage of 5 Volt can be applied to pin 1 of the D-Sub
connector. The current consumption may not exceed
100 mA per
CAN connection.
Do the following to activate the 5-Volt supply:
Danger of short circuit! Take great care when soldering to
avoid short circuits.
Attention! Electrostatic discharge (ESD) can damage or destroy
components on the card. Take precautions to avoid ESD.
1. Unscrew the housing on both sides.
2. Remove the screws next to one of the two D-Sub
connectors.
3. Pull out the board.
4. Solder the solder bridge(s) on the board according to the
desired setting.