Better Solutions Are Within Reach
TM
MODEL NUMBER:
P15LCD to P15X
Document Number:
PD196-212 R1
Mount Removal Instructions
Page 1 of 3
PDi Communication Systems, Inc. 40 Greenwood Lane Springboro, Ohio 45066 USA PH 800-628-9870 FX 937-743-5664
This symbol indicates that dangerous
voltage constituting a risk of electric
shock is present within this unit.
CAUTION
RISK OF ELECTRIC SHOCK,
DO
NOT OPEN!
This symbol indicates that there are
important operating and maintenance
instructions in the literature
accompanying this unit.
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER. NO USER SERVICEABLE
PARTS INSIDE. REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL
THIS INSTALLATION SHOULD BE MADE BY A QUALIFIED SERVICE PERSON AND SHOULD CONFORM TO
ALL LOCAL CODES. READ AND FOLLOW THE SAFETY INSTRUCTIONS BEFORE ATTEMPTING THIS
INSTALLATION.
Note to CATV installer
. This reminder is provided to call the CATV system installer’s attention
to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular,
specifies that the cable ground shall be connected to the grounding system of the building, as
close to the point of cable entry into the room as practical.
WARNING:OXYGEN ENVIRONMENT DO NOT use
in an oxygen tent or oxygen chamber. Such use may
cause a fire hazard.
WARNING: To avoid the hazards of fire or electric
shock, DO NOT expose this TV to rain or moisture.
DANGER: ARM RECOIL HAZARD The safety
brake pin must remain in the SAFETY BRAKE PIN
HOLE whenever the television set is removed from
the arm or when the arm is removed from the wall
bracket to prevent the arm from springing open.
1. Install safety brake pin into Swing Arm with ¼ - 20 acorn nut.
2. Unplug AC and RF connectors at the wall and TV.
3. Lift open nose cover by removing two side screws.(Fig. 1)
4. Remove retainer bolt and lock washer. (Fig. 2)
5. Remove the back channel cover for access to cables. (Fig. 3)
6. Remove the TV from the arm mount.
NOTE:
Cables are not shown for clarity of the view.
Fig. 3
Fig. 2
Fig. 1
