Pco Edge 3.1, Руководство пользователя

Страница: 22 / 59

22
1
2
3
4
7. CAMWARE 4 SOFTWARE
This chapter contains only camera-specific additions to the
pco.camware manual. All main functions and explanations can be
found in the pco.camware manual.
7.1 HARDWARE IO CONTROL
Change settings using the drop-down menu.
For electrical specification, see chapter
A1.3
Exposure Trigger
If checked on, a signal for
External Exposure Start
or
External
Exposure Control Trigger Mode (see chapter 6.3.1 ) is
accepted at the Exposure Trigger SMA input #1.
Exposure Trigger: On; Off
Signal Polarity: Rising; Falling
Aquire Enable
If checked on, a signal for Acquire Mode or Sequence Trigger Mode
is accepted at the
Acquire Enable
SMA input #2.
Acquire Enable: On; Off
Signal Polarity:
High; Low
Status Busy
If checked on, a signal indicating busy status is provided at the status
busy output. Once an acceptable trigger edge is received, ‘busy’
goes to status high. As soon as ‘busy’ goes low again, a new trigger
edge is accepted.
Status Busy: On; Off
Signal Polarity: High; Low
Status Expos
If checked on, a signal indicating exposure or line status is provided
the status output.
Status Expos
indicates the actual exposure
window for one frame. Status Line: use the falling line edge for
optimized synchronization (minimized jitter; see page 16 ).
Select IO Signal:
Status Expos; Status Line
Signal timing:
Show time of ‘First Line’; Show common time of ‘All
lines’; Show time of ‘Last line’; Show overall time of ‘All lines’
Status Expos: On; Off
Signal Polarity:
High; Low
1
2
3
4
1
2
3
4