© PCE Instruments
7
6
Switching on and off
To switch the meter on and off, press the on/off switch. The measurement is made after a few
seconds. To switch the meter off again, press the on/off switch again.
7
Backlight
When the meter is switched on, the backlight is activated. To switch off the backlight, press and
hold the "ECO" key for two seconds. To switch the backlight back on, press and hold the "ECO"
key again for two seconds.
8
Making a measurement
To make a measurement, first connect the earthing cable to the meter and to an earthed
conductor. Then switch on the meter. The measurement will start after a short time. Point the
measuring device at the object to be measured. You have reached the correct distance as soon
as the lasers cross. Now you can read the measured value.
9
Zeroing
To zero the meter, first ground it with the earthing cable. Then switch on the meter and wait until
the reading has stabilised. Then press the zero key to set the displayed reading to zero.
NOTE:
Make sure that there is no static charge on the sensor side. This can influence zeroing.
