© PCE Instruments
5
8.1
Menu structure
Menu
Calibration
(Calib)
Zero point calibration
(Zero Calib)
Factory calibration
(Factory calib)
1-point calibration
(1 point calib)
5-point calibration
(5-point calib)
Data groups
(Data Group)
History
Selected group
(Select Grp XXX)
Delete last value
(Remove latest)
Delete group
(Erase group)
Clear memory completely
(Erase all)
Limit value alarm
(Limit Alarm)
Activate alarm
(alarm on)
Upper limit value
(Up limit)
Lower limit value
(Low limit)
Bluetooth
On, off
(ON, OFF)
Unit
µm, mil
Device information
(About)
Sensor type
(Type)
Serial number
(Serial)
Hardware version
(Hardware)
Software version
(Software)
9
Calibration
To perform a calibration, the meter has various functions.
-
Factory calibration
-
Zero point calibration
-
One-point calibration
-
Five-point calibration
In order to obtain the most accurate measurement result over the entire measuring range, a five-
point calibration is recommended. A calibration of magnetic (Fe) and non-magnetic substrates
(nFe) is independent on each other. After each calibration, check the measured values again with
the references. If the measured values are still not within the accuracies, repeat the calibration if
necessary.
