© PCE Instruments
6
6.4
Configure meter
To configure the meter, connect the PCE-ADL 11 to the PC. Then click on the "Setting" icon.
Another window opens and the software automatically connects to the meter.
Parameter
Meaning
Basic settings
Model Select
Instant: The meter starts the measurement directly after you
confirm the configuration via "Setup".
Important
: A live view is not possible.
Manual: The meter starts the measurement after you press the
start key on the meter.
Current Time
Current time of your PC. This time is also transmitted to the
meter.
Sample Point
Number of measuring points to be recorded
Sample Rate
Specification of the storage rate
Recording Time
This indicates how long the meter measures with the settings
made until the measurement is finished.
LED Flash Cycle
Here you can specify when the status LED should light up
Alarm settings
LED flash
Here you can specify whether the alarm LED flashes when the
limits are exceeded or not reached.
Low Alarm
Here you can enter the limit value for the lower limit.
High Alarm
Here you can enter the limit value for the upper limit.
Unit
Here you set the unit in which the meter records the data.
Important:
The
unit of the recorded data cannot be changed
afterwards.
More buttons
Default
The configuration is reset here.
Setup
Here the configuration is transferred to the PCE-ADL 11.
Attention:
The
already saved measurement data will be
deleted.
Cancel
No data is saved and the window closes.
