© PCE Instruments
7
3.8
Getting started
-
Check that the transmission meter is correctly connected to a computer via the USB
cable.
-
Make sure that the measuring instrument is connected to the mains power supply and
switch it on.
-
Start the software on the PC.
-
When all the above measures have been taken, the following graph is displayed:
-
If the error message shown below appears, the software must be terminated. Then
connect the device to the computer via USB again and restart the software. Please
contact PCE Instruments if this error occurs repeatedly.
-
If the unit is connected via a USB hub, problems may occur. In this case, connect the
unit directly to the computer.
