PCB Piezotronics Larson Davis BAS002, Руководство пользователя

Страница: 14 / 75

BAS002 2-2
Assembling the Amplifier and Speaker
To prepare the amplifier and connect it to the speaker, follow
these steps:
Remember to turn the antenna
horizontally (or remove it) when
transporting to avoid damage. Step 1 Mount the antenna, screwing it on the gold-plated
connector on the on the front panel.
Step 2 Before connecting the power cord, check that the
mains voltage is in the correct range for the version
purchased: BAS002-U 90-132.5 VAC (55-65 Hz) or
BAS002-E 190-265 VAC (45-55 Hz). The power supply
specifications are displayed on the back panel.
Step 3 Place the amplifier vertically on a firm surface and
place the tripod in a stable position.
Always stop signal generation and
disconnect AUX in before connecting
or disconnecting the speaker cable. Step 4 Connect the amplifier to theBAS001 or BAS003
with CBL182 (Speakon cable). Insert the plug into the right
side CBL182 connector of the amplifier. Only one position
is allowed. Turn it clockwise until you hear the locking
click. Repeat the same steps to connect the source side.
Step 5 Connect the AC power cord.
Installing the Remote Control Battery
To install the PP3 battery in the remote control, follow these
steps:
Step 1 Remove the remote control from the rubber boot.
Step 2 Open the bottom slide to access the battery
compartment. Note the polarity indicators and insert the
battery accordingly.