PAX A920 Pro
Configuration and Installation
Copyright © 2021 PayFacto Inc.
Page 6 of 20
After you remove the terminal and accessories from the box, you need to charge the terminal before you
can use it. The pre-installed battery has a protective cover on the contacts to prevent the possibility of a
short circuit during transport.
To charge the terminal:
NOTE: The terminal’s charging port may have a protective
cover; you will need to remove it before inserting the USB
Type-C connector.
Turn the terminal over.
1.
On the back of the terminal at the bottom, slide the battery cover locking switch to the
right.
2.
Lift the battery cover off the terminal. You should notice a plastic tab at the top of the
battery.
3.
Lift the battery from the terminal and remove the plastic tab.
4.
Re-install the battery and push on the bottom of the battery to seat it correctly.
5.
Re-install the battery cover on the terminal and slide the lock switch to the lock
position on the left and turn the terminal over.
6.
Insert the USB cable in the AC outlet and connect the outlet to an AC plug.
7.
Insert the USB Type-C connector in the terminal’s charging port, located on the left
side, below the
Volume control
button. The terminal begins charging.
8.
