19
User and installation instructions
Installer information – EN
R75
30°
65°
95°
J.
Mark the three attachment points for the appro-
priate screws to the substrate (Figure J).
Pax follows industry regulations for Safe Water in
-
stallation, drilling and sealing with silicone according
to the instructions for wooden walls and concrete.
These must be followed. (See page 25).
Tighten the screws so that the seal forms a seal
against the wall.
Always use a qualified electrician
All 100-240 V electrical connections must be per-
formed by a qualified electrician. The power must be
cut during all electrical work on the product.
The wall frame contains an electronics component
with terminal blocks for 100-240 V AC and 12 V DC.
Electrical connection can be made according to
the wiring diagram on page 20-21.
NB: As the two legs of the motor unit protrude
into the wall frame, and one leg is in contact with
the switching contact, cables must be laid in the
wall frame as shown in Figures K/K1 (100-240 V AC
connection) and L (12 V DC connection), so that no
cables block the path of the leg.
K.
K1.
L.
100-240 V AC
connection
12 V DC connection
