Patton SmartNode 4970A Series, Руководство пользователя

Страница: 15 / 57

SmartNode 4970A rear panel 15
SmartNode 4970A User Manual 1 • General information
SmartNode 4970A rear panel
The SmartNode 4970A rear panel ports are described in table 2.
Figure 2. SN4970A rear panel
Table 2. Rear panel ports
Port Description
ETH 0/0
Auto-MDX Gigabit-Ethernet port, RJ-45 (see
figure 2
), connects the unit to an
Ethernet WAN device (for example, a cable modem, DSL modem, or fiber modem).
Note: Only full duplex modes are supported.
PRI 0/0 - PRI 0/3 RJ-45 connector providing E1 (2.048Mbps) or T1(1.533 Mbps) PRI interface, meet-
ing all requirements of ITU-T recommendations for G.703. Use a shielded E1 or T1
interface cable for 120 Ohm balanced connections to connect the SmartNode with
an NT or ET, e.g. a PBX or LE.
Console
Used for service and maintenance, the Console port (see
figure 2
), an RS-232 RJ-
45 connector, connects the product to a serial terminal such as a PC or ASCII ter-
minal (also called a dumb terminal).
Configuration settings : 9600 bps, 8 bits, no parity, 1 stop bit, no flow control
DC power input
Electricity supply socket. (see
figure 2
).
Reset
The reset button has several functions, as described in appendix F,
“Reset Button
Functions”
on page 51.