Pattfield Ergo Tools PE-1024, Оригинальное руководство пользователя

Страница: 81 / 83

EN 160 EN 161
Technical Data
Model Pattfield Compressor 24L
PE-1024 PE-1024CH
Model No. 10468364 10468365
Plug EU plug Swiss plug
Nominal voltage 220 – 240V~, 50 Hz
Rated power *) 750 W (S3/50%)
Protection class I
Degree of protection IP30
Max. speed of motor 1450 min -1
Suction capacity 129 l/min
Tank capacity 24 l
Max. operating pressure 8 bar
Sound pressure level (L
pA
)@7m 58 dB(A)
Uncertainty K 3 dB(A)
Sound power level (L
WA
) 76.5 dB(A)
Uncertainty K 1.9 dB(A)
Guaranteed sound power level (L
WA
) 78 dB(A)
Lubrication oil free
Weight 23.2 kg
Dimensions 58 x 25.5 x 58 cm
Ambient temperature +5 °C to +40 °C
Ambient humidity > 50%
Max. altitude 1,000 m
Max. setup inclination 10°
Noise
The values given in these instructions have
been measured in accordance with a stand-
ardized measurement procedure specified in
EN 3744 under operation conditions according
to point 9 Part B Annex III EU-RL 2000/14/EC
and can be used to compare machines.
It may be used for a preliminary assessment
of exposure.
Troubleshooting
Problem Cause Remedy
Compressor doesn‘t
work
No power supply Check cable, power plug, fuse
and power outlet
Power supply too low Avoid too long extension cords
Outdoor temperature too low Do not run compressor at out-
door temperatures below +5 °C
Motor overheated Let motor cool down. Remove
overheating cause if possible.
Press the overload switch 9
Compressor runs, but
generates no pressure.
Safety valve 10 leaky Contact service
Sealing is broken Check sealings. Have sealings
replaced by your HORNBACH
store
Drain screw for condensation
water 12 leaky
Tighten screw. Check sealing of
drain screw. Replace sealing if
necessary
Compressor runs, pres-
sure is shown at the
pressure gauge, but
tools don't run.
Hose connection leaky Check compressed-air hose
and tools, replace if necessary
Fast coupling at air outlet 5
leaky
Contact service
Pressure is set too low at the
pressure regulator 4
Turn pressure regulator 4
Warning! Service work on the safety valve and on all other pressure parts must be
performed only by qualified service.