EN
102
EN
103
tempting to dislodge a bound or jammed
bit.
Fragments of metal from the bit could
dislodge and strike you or bystanders.
h)
Never place the tool down until the bit or
accessory has come to a complete stop.
Do not use dull or damaged bits and ac-
cessories.
Dull or damaged bits have a
greater tendency to bind in the workpiece.
i)
When removing the bit from the tool
avoid contact with skin and use proper
protective gloves when grasping the bit
or accessory.
Accessories may be hot after
prolonged use.
j)
Do not run the tool while carrying it at
your side.
The spinning drill bit may be-
come entangled with clothing and injury
may result.
k)
Brace the tool properly before use.
This
tool produces a high output torque and
without properly bracing the tool during op-
eration loss of control may occur resulting in
personal injury.
l)
Hold power tool by insulated gripping
surfaces, when performing an operation
where the cutting accessory may con-
tact hidden wiring or its own cord.
Cut-
ting accessory contacting a “live” wire may
make exposed metal parts of the power tool
“live” and could give the operator an electric
shock.
II. Safety instructions when using long
drill bits
a)
Never operate at higher speed than the
maximum speed rating of the drill bit.
At
higher speeds, the bit is likely to bend if al-
lowed to rotate freely without contacting the
workpiece, resulting in personal injury.
b)
Always start drilling at low speed and
with the bit tip in contact with the work-
piece.
At higher speeds, the bit is likely to
bend if allowed to rotate freely without con-
tacting the workpiece, resulting in personal
injury.
c)
Apply pressure only in direct line with
the bit and do not apply excessive pres-
sure.
Bits can bend causing breakage or
loss of control, resulting in personal injury.
Declaration of conformity
We declare, that the product
described in
Technical Data
:
800 W Impact Drill PDI800G2
manufactured for:
HORNBACH Baumarkt AG
Hornbachstraße 11
76879 Bornheim / Germany
is in conformity with the following directives:
Machinery Directive 2006/42/EC
EMC Directive 2014/30/EU
and in accordance to the following applicable
harmonized standards:
EN 62841-1:2015
EN 62841-2-1:2018
EN 55014-1:2006+A1+A2
EN 55014-1:2017
EN 55014-2:2015
EN IEC 61000-3-2:2019
EN 61000-3-3:2013+A1
Andreas Back
Head of Quality Management, environment &
CSR
Person authorised to compile the technical file
Bornheim, 21.01.2022
HORNBACH Baumarkt AG
Hornbachstraße 11
76879 Bornheim / Germany
