EN
122
EN
123
PARALLEL GUIDE
Attach the parallel guide
8
as shown
and set the desired parallel distance.
If the tool is not in use the parallel guide
can be used as a blade guard.
1
REBATING
Attach the rebating depth guide
4
as
shown and set the desired rebating
distance from 0 - 15.5 mm.
1
BEVELING
The three V-grooves in the front of the
base plate allow quick beverling. Place
the V-groove of the desired size on the
edge and guide it along.
2
DEPTH ADJUSTMENT
To set the desired planing depth from
0 - 3 mm, rotate the depth adjustment
knob
6
.
Each click adds / decreases 0.2 mm.
1
Set the disired distance on the parallel
guide
8
in order to make rabbets. Plane
as often as necessary to achieve the
desired rabbet.
2
The current depth adjustment can be
read at the indicator on the depth ad-
justment knob
6
.
2
BLADE REPLACEMENT
Use a 8 mm wrench to loosen the three
screws.
1
Adjust the height of the blade assembly
with the hex key and securely tighten
the three screws loosened in step 1.
There are two blades on the spindle!
4
Replace the blade or the complete
blade assembly and slide it back into
the tool so that it runs freely.
3
Open the blade cover
3
and slide out
the blade assembly.
2
Caution!
Make sure the tool is
switched off and unplugged.
Caution!
The blade is sharp.
Caution!
Always use identical
blades and blade assemblies.
Caution!
Make sure the blade is
placed in the correct position.
1
2
1
2
4
1.
1.
2.
2.
1
1.
1.
2.
2.
3.
3.
3
2
1
2
