MANUAL
21846
AILONET 100
6.6.2002
AILONET USER MANUAL
Done
Copyright
Patria Ailon Oy 2002. All rights reserved.
7/24
1.3
System Setup
1.3.1 First Connection Using Serial Port
By default Ailonet serial port is configured for a PC with direct cable connection. Use supplied se-
rial port cable (RJ45 – D9) to make the physical connection between Ailonet’s and PC’s serial
ports. To configure Windows 98/Me/2000/XP properly for direct cable connection, refer to Windows
help (Start->Help) with keyword “Direct Cable Connection”.
Make the direct cable connection using the following parameters:
Speed:
38 400 bps
Handshaking: CTS/RTS (or Hardware)
Data bits:
8
Stop bits:
1
Parity:
None
Username:
dialin
Password:
dialin
1.3.2 First Connection Using Bluetooth
The Ailonet Bluetooth network is configured by default to be discovered publicly. Ailonet Bluetooth
device name, PIN code (optional) and IP address can be found from CONFIGURATION STATUS
LIST – AILONET SAMPLE INFORMATION document delivered with the unit.
To access Ailonet from a Bluetooth enabled PC or PDA, use web browser to connect to
(please verify the IP address from CONFIGURATION STATUS LIST – AILONET SAMPLE IN-
FORMATION)
1.3.3 First Connection Using 802.11b
Ailonet can be accessed via 802.11b network, if both PC/PDA and Ailonet are equipped with IEEE-
802.11b network PC Cards. See section “Supported PC Cards” for further information.
DHCP configuration, network name, encryption key and possible fixed IP address can be found
from CONFIGURATION STATUS LIST – AILONET SAMPLE INFORMATION document delivered
with the unit.
NOTICE: If Ailonet is configured to be a DHCP Client for 802.11b, it can not be accessed from
802.11b network – it can only act as a gateway from another interface (Bluetooth, Ethernet, etc.) to
802.11b. This is due to fact that there’s no easy way of finding out Ailonet’s 802.11b IP address.
To access Ailonet via 802.11b, use web browser to connect to
(please verify the IP address from CONFIGURATION STATUS LIST – AILONET SAMPLE IN-
FORMATION)
