MANUAL
21846
AILONET 100
6.6.2002
AILONET USER MANUAL
Done
Copyright
Patria Ailon Oy 2002. All rights reserved.
24/24
be defined which is written in the form 192.148.166.0/24. IP-addresses are separated with line
spacing.
Example:
The IP-address and the mask have the form 192.168.44.128/24. Thus, the first 24 bits of the ad-
dress are compared. The firewall gets the packets 192.168.44.3 and 192.168.23.128. The first
three segments of the first address
192.168.44
.3 are the same as those of the entered IP-address,
and so it gets through, and the segments of the second address
192.168.23
.128 are different, so it
doesn't get through.
By clicking
Save
you can save the changes you have made and by clicking
Reset
you can return to
the settings which were valid when you entered the page. If you click Cancel, you return to the
view where you choose the profile to be modified.
Ports can be added to the list one by one by entering the port number to the lowest field,
Port
, and
by choosing a protocol for the port. You can either define one port or a port area that the setting
involves. A port area is defined with a colon
[:]
, the left side of which is the start port and the right
side the end port. For example the port sequence 21-45 is marked as 21:45. The setting involves
all ports between these numbers. If there is no number on the left side, the list starts from the zero
(0) port. If there is no number on the right side, the end port number is 65535. The port has three
protocol alternatives:
TCP, ICMP, UDP and ALL
.
ALL
means all three. The settings of the new port
become valid after clicking the
Save
button, after which a new empty space appears for the defini-
tion of the next port. You can add the new ports of your choice to the firewall by repeating the
modifications and savings. If you want to remove added ports, choose
Remove
on the left side of
the port settings and click
Save
.
2.3.10.3 Factory settings
You can return all profiles to their factory settings from the window
Factory settings
.
Modifying firewall settings step-by-step
1.
In Ailonet’s user interface, browse to
SETTINGS->Firewall Interfaces
2.
Choose Ethernet profile.
3.
Choose WLAN profile.
4.
Choose profiles for other interfaces.
5.
Click
Modify
, and the chosen profiles activate.
6.
Go to the view
SETTINGS->Firewall Advanced
(if you don't want to modify profiles, go on to
11).
7.
Choose interface to be modified.
8.
Choose profile to be modified.
9.
Start modifying by clicking
Modify
.
10. Choose settings for different ports or add ports.
11. Click
Save
. The firewall settings have been changed.
