PATON VDI SERIES ECO DC MMA
- 12 -
Parameters:
VDI-160E
VDI-200E
VDI-250E
Rated power supply voltage 50/60 Hz, V
~230
~230
~230
Power supply voltage range
170 – 260
170 – 260
170 – 260
Efficiency coefficient (at 200A), %
90
90
90
Welding current-control range, A
20 – 160
25 – 200
32 - 250
Welding current at a load factor of 40 %,
for 5 minutes
Welding current at a load factor of 100 %,
for 5 minutes
160 А
101 А
200 А
126 А
250 А
158А
Maximum consumed power, kVA
5,5
6,9
8,8
Normal operating voltage in the manual arc
welding mode
20,4 – 26 V
20,4 – 26,5 V
20,4 – 27,0 V
9. DELIVERY SET
1.
Welding unit with a power cable 3 m in length
– 1 pcs;
2.
Shoulder-carry belt
– 1 pcs;
3.
Brand corrugated box
"PATON™"
– 1 pcs;
4.
Welding cable with an electrode holder, 3 m in length
– 1 pcs;
5.
Welding cable with an earthing terminal, 3 m in length
– 1 pcs;
6.
Operation manual
– 1 pcs.
10.
TROUBLESHOOTING
Fault
Fault cause
Fault recovery
No welding currents.
The power is switched on;
the green indicator does not
light.
Power cable breakdown
Check the state of the power
cable.
Power supply voltage is below
155 V.
Connect the welding unit to the
power supply system with
proper voltage.
Power supply voltage exceeds
260 V (the indicator on the rear
panel lights).
Connect the welding unit to the
power supply system with
proper voltage.
Fault of the internal power
supply module of the welding
unit
Apply to the service center.
