Paton MultiPRO Series, Техническое описание и руководство по эксплуатации

Страница: 9 / 44

- 9 -
PATON MultiPRO series DC MMA/TIG/MIG/MAG
a) in case of MMA welding – for connection of “earth” cable (very
occasionally electrode cable can be connected, if special electrodes are
used);
b) in case of TIG welding – only argon torch is connected;
c) in case of MIG/MAG
solid wire welding – “earth” cable is connected;
d) in case of semiautomatic MIG/MAG fluxing wire welding – “earth” cable is
connected internally to the feeder.
13 – Socket of control buttons on the torch in case of TIG welding.
14 – Socket of shielding gas supply to the torch in case of TIG welding.
15 – The input for leading-in welding wire.
16 – Fitting for shielding gas supply, when using a semiautomatic torch;
17 – Cable for supplying control signals from the wire-feeding machine to the
welding current source.
18 – The on / off button of the device (color is decorative).
19 – The coil holder for a wire with a spring braking mechanism.
20 – Fitting for shielding gas supply, when using an argon torch.
2. START‐UP
Attention! Before start-up and commissioning, please read the section
“Safety rules”, Clause 15.
2.1 INTENDED USE
The welding machine is designed solely for manual metal arc welding with a
stick electrode, tungsten arc inert gas welding, as well as semiautomatic metal
inert/active gas welding.
Other use of the machine is considered undue. The manufacturer is not
responsible for damage caused by undue use of the machine.
Intended use of the machine implies adherence to the instructions of this
operating manual.
2.2 INSTALLATION REQUIREMENTS
The welding machine is protected from ingress of foreign solid objects of
more than 5.5mm in diameter.
The welding machine can be placed and operated outdoors. Internal electric
parts of the machine are protected against direct moisture impact, but not against
condensate drops.
ATTENTION! Do not switch the machine off immediately after completion of
welding works in hot weather or intense welding works in any weather conditions!
Electronic parts must be allowed to cool down for 5 minutes.