Paton MultiPRO Series, Техническое описание и руководство по эксплуатации

Страница: 19 / 44

- 19 -
PATON MultiPRO series DC MMA/TIG/MIG/MAG
Procedure for machine preparation to operation:
- disconnect all cables from the wire feeding mechanism;
‐ insert the torch cable into the source socket B “–” ;
- screw the gas plug from the argon torch tightly to the socket 14 ;
- insert the socket of the torch control buttons to the socket 13 ;
‐ insert the “mass” cable into the source socket А “+” ;
‐ connect the “mass” cable to the work piece;
- install the pressure reducer on the gas bottle;
- connect the torch gas hose to the gas bottle pressure reducer and the plug on
the rear panel of the source;
- open the gas bottle valve, check the tightness;
‐ connect the mains plug of the source to the supply mains;
‐ set power switch
18 on the rear panel to position “I”;
‐ set the TIG welding mode by pressing the button 4 ; the modes switch over
end‐around;
‐ set the function of the button of the TIG‐LIFT torch by pressing button
3 until
the indicator shows [But], in 0.2s after the button is released, the machine will
display current positions of this function: use buttons
2 to set it to [2t]. If nothing
is done for a long time, the machine will leave this function. You can return to it in
the same way, and if you skipped the required welding mode, press button
3
again—the modes switch over end‐around;
‐ use buttons
2 to set the arc current after the machine goes to the main
parameter;
‐ if necessary, additional functions of welding process can be adjusted—see a
changeover sequence in Clause 6.1.