Paton MultiPRO Series, Техническое описание и руководство по эксплуатации

Страница: 11 / 44

- 11 -
PATON MultiPRO series DC MMA/TIG/MIG/MAG
3. MANUAL METAL ARC WELDING WITH A STICK
ELECTRODE (MMA WELDING)
In this welding mode, the wire-feeding machine is not needed!
Procedure for machine preparation to operation:
- disconnect all cables from the wire feeding mechanism;
‐ insert the electrode cable into the source socket А “+” ;
‐ insert the “mass” cable into the source socket B “–” ;
‐ connect the “mass” cable to the work piece;
‐ connect the mains plug to the supply mains;
‐ set power switch
18 on the rear panel to position “I”;
‐ set the MMA welding mode by pressing the button 4 ; the modes switch over
end‐around;
‐ use buttons
2 to set the main parameter, which is welding current;
‐ if necessary, additional functions of welding process can be adjusted—see a
changeover sequence in Clause 6.1.
Attention!
Once the power switch is set to position “I” in the MMA welding mode,
the stick electrode becomes energized. Do not touch conductive or earthed
objects, such as, for example, welding machine frame, etc., with the electrode,
since the machine will take this as a signal to start the welding process.
3.1 WELDING CYCLE – ММА
See Clause 6.1 for sequence of changing the value of any function.
Electrode holder
Ground terminal
Product
t, s