Paton MultiPRO Series, Техническое описание и руководство по эксплуатации

Страница: 10 / 44

PATON MultiPRO series DC MMA/TIG/MIG/MAG
- 10 -
ATTENTION! When the machine is switched off and cools down after an
operation in cold season, condensate forms inside of it, so do not switch the
machine on again in less than 3...4 hours!!!
Therefore, do not switch the machine off in cold season, if you are going to
switch it on within 4 hours.
The machine must be placed to ensure free inlet and outlet of cooling air
through the vent holes on the front and the rear panels. Take care that metal dust
(for example, during emery grinding) does inhaust directly into the machine by the
cooling fan.
ATTENTION! The machine may be life‐threatening after a hard fall. So
place it on a stable, solid surface.
2.3 POWER CONNECTION
The welding machine of series design is rated for mains voltage of 220V (-
27%+18%) or for three‐phase mains voltage of 3х400V (
±
20%) with neutral wire .
Attention! All manufacturer’s warranty liabilities become void if the
single‐phase machine MultiPRO-250 is connected to mains voltage exceeding
270V ! Such a situation can occur with a very large phase voltage imbalance in a
standard mains or using non-standard connection.
When connecting three‐phase machine MultiPRO-250-400V, manufacturer’s
warranty liabilities become void if the mains line has been connected by mistake to
the neutral wire , as well as when connecting to the mains with large distortions
in the neutral wire .
Mains connector, cross‐sections of power supply cables, and supply‐line fuses
must be selected on the basis of technical specifications of the machine.
2.4 MAINS PLUG CONNECTION
Attention! Mains plug shall correspond to supply voltage and current
consumption of the welding machine (see Technical specifications). In accordance
with safety practices, use a sockets with a
guaranteed earthing and in no case do
not use a neutral wire for these purposes!!!