Patlite WIO-B1T, Инструкция по эксплуатации

Страница: 24 / 88

Wireless Control Unit
24
7. Operation
7.3.2. Function Settings
This product has "Level Mode," "One-shot Mode", and "input logic switching" functions.
Assign functions by turning this product’s Function DIP switch ON and OFF. For details on how to set functions,
refer to "7.3.2.1. How to Set Functions".
Point
●
"Level Mode" is recommended for the following usage conditions.
• When using alternating-type switches, such as toggle switches
• When inputting from a PLC or other device in the equipment
●
"One-shot Mode" is recommended for the following usage conditions
• When using momentary switches such as pushbutton switches
• When using a sensor that outputs only at the moment of detection
7.3.2.1. How to Set Functions
• Turn DIP switches No.1 to 3 ON or OFF to set functions.
• Read "7.2. About the DIP Switches and Reset Button" (
☞
page 20) before handling the DIP switches.
Head Cover
❷
❹
❸
Function DIP Switch
WIO Body
Unit
Remove the head cover from the WIO body unit.
❷
Set the Function DIP switch.
❸
Attach the head cover to the WIO body unit.
❹
Confirm the product to set is turned off.
❶
• For details on each function, refer to "List of Functions
for the Function DIP Switch" in the next section.
• Do not use switch No. 4.