pathway Pathport PWPP HH P1 XLR5F, Руководство пользователя

Страница: 10 / 62

October 2021
3
PWPP HH P1 - Manual
The rear-mounted hanging bracket accepts a 1/2” (12.5mm) bolt, and is intended to be suspended using a standard C-clamp
or similar pipe hanger. A separate anchor point is provided for a secondary safety. The bracket may be installed in 90 degree
increments as needed.
The PWPP HH P1 has an IP54 enclosure rating when mounted so the cable connections point directly downward.
INSTALLATION ENVIRONMENT
The PWPP HH P1 is intended for installation in a dry, indoor location. Ambient operating conditions are 14°F to 122°F (-10°C
to 50°C); 5-95% relative humidity, non-condensing.
Warning: All ports on the PWPP HH P1 are intended for low voltage and/or data lines only.
Attaching anything other than low voltage sources to the data ports may result in severe
equipment damage, and personal injury or death.
POWER
The PWPP HH P1 will operate on IEEE 802.3af Power-over-Ethernet (PoE) as a class 1 device, drawing less than 5 Watts. It
will also operate on a standard 9V battery (included, already installed in device).
The gateway will automatically sense the presence of PoE and will use it rather than the battery. However, the device will not
automatically switch to battery power if PoE is subsequently lost or disabled.
When operating on battery power, the PWPP HH P1 will shut down after 30 seconds without a button push, to conserve the
battery. One 9V battery will provide at least 30 minutes of configuration operations. The PWPP HH P1 is not intended to be
used extensively or permanently on solely battery power. For normal show operation, the device is intended to run on PoE.
REPLACING THE BATTERY
Disconnect any PoE source before replacing the battery.
To replace the internal battery, remove the two battery compartment screws on the bottom rear of the gateway.
Hanging Bracket (Included)
3 Button Interface
RJ45 Ethercon
XLR5F DMX Connector
Battery Compartment
Battery Compartment
Screws (x2)
LCD Screen
Safety Attachment Ring
Disconnect the battery from the connector, and replace with a fresh 9V battery, observing the polarity of the contacts. Replace
the cover and re-tighten the battery compartment screws.