2, 4
3
3
Ø
×
Note: when you
see
Ú
in the
instructions, press
the top and the
bottom of the
device rocker for 2
seconds
3
How to install and use the
radioMiro
TM
radio repeater
English
Read and retain these instructions
Français
Español
Ready?
Application
For more
information
on designing,
installing and using
radioMiro
TM
systems, and for expert
technical
help
, visit our web site at
www.passandseymour.com/miro
Use the
radioMiro
TM
radio repeater in large
installations, where the standard range
(approximately 25m/80’) is insufficient, or in
buildings with difficult radio reception
conditions.
The radio repeater will effectively double the
transmit/receive range of
radioMiro
TM
devices. In very large installations you may
use up to five repeaters, strategically
located.
The radio repeater also offers a great
security feature – real life occupancy
emulation. It records a one-week loop of real
radioMiro
TM
network traffic, and can play it
back when you’re away from home – it’ll look
just like you’re there.
Note that, while we definitely recommend the
repeater for either or both of these functions,
we recommend that you use only the number
required for effective radio communication
throughout the home. Using too many
repeaters will not provide any additional
benefit and may slow down network
communication. For in-depth system design
guidance, go to
www.passandseymour.com/miro.
Installation
Figure 1
Locate the repeater in a central location,
taking into consideration both the horizontal
and vertical space in the home. In a 2-story
plus basement home, a good position may
be on the first floor atop a kitchen cabinet.
Do not locate close to any device that may
cause interference – fluorescent light
fixtures, TV sets, computers etc.
Plug the external power supply into a
convenient 120 volt outlet, and connect the
power cord to the repeater’s power socket.
The status LED will light yellow, indicating
that the unit is ready for configuration.
Get Set…
Configuration
Figure 2
1.
To prevent interference between
neighboring systems,
radioMiro
TM
devices
must acquire a unique house ID before use.
It’s simple!
1.
With all devices installed and energized,
check that every
radioMiro
TM
device is
showing a yellow LED. If not, check that
the circuit breaker is on and that the
device is correctly installed.
2.
All devices in a home must be ‘bound’ to
the same home ID. For a new
radioMiro
TM
installation, simultaneously
press and hold the top and bottom (
Ú
) of
any device paddle for 2 seconds. Its LED
flashes yellow, indicating that it has
acquired a unique House ID.
3.
Check that all other
radioMiro
TM
device
LEDs are flashing green, indicating that
they have acquired the same House ID.
4.
Return to the first device, and press
Ú
again for 2 seconds. All device LEDs
revert to green, indicating that house
binding is complete.
Note: if you’re adding the device to an
existing
radioMiro
TM
installation, simply
press and hold
Ú
on any previously bound
device for 2 seconds to start the procedure,
verify that the newly added device LED is
Need Graphic
for external
power supply
Home
Status
LED
Away
