Bernese Mountain Dog G2
Page 3 of 16
Battery and Router Installation
Step 1: Mount the OmniCharge 20K Battery Pack to the Cover Plate.
A.
This step only applies to the Bernese Mountain Dog G2.
B.
Insert the battery pack into the battery tray, as shown in Figure 1.
C.
Secure the Battery Tray with the Qty. 3 PTA0399-TL screws, as shown in Figure 2.
Figures 1-2: Insert the battery pack into the battery tray and secure the Battery Tray.
Step 2: Mount the router to the cover plate.
A.
Remove the Router Plate from the Cover Plate Assembly as shown in Figure 3 to be able to easily
install the router to the Router Plate.
A.
Remove the film from the display covers as shown in Figure 4.
B.
Mount the router using the four PTA0885 Screws, four PTA0140 Washers, four PTA0844 Lock Washers,
and four PTA0408 Nuts provided in the kit, as shown in Figure 5.
C.
Ensure the router orientation is correct as shown in the images below. The router display should be
visible through the slot(s) in the cover plate.
