INSTRUCTION REF: IN149
ISSUE No. 1
DATE 22.03.07
Page 3 of 16
TELEPHONE:
SERVICE (44) 01332 875665
FAX: SERVICE (44) 01332 875536
INSTALLATION
1.
Place the oven on a level surface allow a clearance between
the wall and the unit of at least 5cm.
N.B. The control panel should not be next to a heat source.
2. ELECTRICAL CONNECTION
·
This unit must be installed by a qualified electrician.
·
Your mains supply (voltage, current, fuse protection) must conform
to technical data plate on unit.
·
The supply voltage during operation must not vary from the normal
voltage level by more than ±10%
·
It is essential to earth the appliance using the terminal with the
symbol on the internal terminal block.
3.
WATER CONNECTION
There are 2 x water connections at rear of the unit, these are
connected by the 2 x hoses via the 1 x Y piece connector supplied.
IMPORTANT NOTE
A water treatment unit must be fitted to the machine to avoid scale and
harmful minerals to enter the cavity of the oven.
Failure to do so will affect the life span of the oven and it will invalidate
your warranty.
4.
DRAIN CONNECTION
A suitable tundish or receptacle should be used directly
underneath the drain outlet allowing an air gap of at least 60mm.
