a
Worktop
Fixing bracket
Screw
It is important to fix this gasket evenly , without gaps or overlapping to prevent liquids from seeping underneath the hob.
not to damage the ignition plugs and the thermocouples.
Secure the hob to the underside of the worktop using the fixings provided.
Screw one end of the bracket into the pre-drilled holes in the underside of the hob.
The other end of the bracket should be located underneath the worktop to secure
Inserting and fixing the hob
Before inserting the hob into the work surface, place the adhesive seal (a) around the underside edge of the hob.
1) Remove the pan stands and the burner caps then turn the hob upside down, taking care
2) Place the gasket around the bottom edge of the hob as shown in the illustration overleaf (left).
3) Place the hob in the installation opening and push it down so that the hob is resting firmly
on the cabinet.
4) Secure the hob in position using the fixing brackets supplied.
the hob in position.
ELECTRICAL CONNECTION
Replace the injectors with the corresponding injector from the table on page below.(see fig. 6).
First remove the burner caps and rings and with a socket spanner "B", unscrew Injector "A" (see fig. 6).
The adjustment of the reduced rate position is as follows (fig. 7): Light the burner and turn the knob to reduced rate position.
C
D
B
A
Fig. 6
Fig. 7
Z $
electricity supply in order for the ignition to work. Insert the power plug firmly into an appropriate electrical outlet and switch on
power at the outlet.
# +
appliance.
The outlet voltage and circuit frequency must correspond to the voltage stated on the appliance rating label.
+ $
avoid a hazard.
The power supply cord must not touch the hot parts of the cooktop.
$
such work must be carried out by an appropriately qualified, licensed electrician.
Gas connection
` Q
point must be accessible without having to remove the cooktop. If a flexible hose is used, the connection point must also be
accessible without having to remove the cooktop.
' [ $*
“OUT” port of the regulator towards the gas inlet pipe of the cooktop, as illustrated in. Using a suitable thread sealant, screw the
regulator on and ensure that it is orientated with easy access to the test point Connect the appropriate Natural Gas supply to the
“IN” port of the gas regulator.
15mm
HX-3-6S-3GW HX-3-6W-3GW
HX-3-9S-4GW
HX-2-6S-4G
5
