Parkside PTHSA 20-Li A2, Перевод оригинальной инструкции

Страница: 12 / 80

12
IE NI GB
B
assembling
Remove the rechargeable bat-
tery from the device before
assembly. Insert the recharge-
able battery only once the de-
vice is completely assembled.
There is a risk of injury!
Use only original parts.
1. Unpack the device and check for com-
pleteness.
2. Slide the motor head (2) onto the tubu-
lar shaft of the telescopic tube (6). Slide
the motor head (2) up to the assembly
stop (18) onto the telescopic tube (6).
The position is preset by the fixation pin
(18). Ensure that the nuts and grooves
latch into one another. See detailed
view in illustration
B
.
3. Secure the motor head (2) and the tel-
escopic tube (6) with the cap nut (5).
To do this, screw the cap nut (5) in the
clockwise direction on to the
thread of the motor head mounting
(17) and tighten the cap nut (5) by
hand.
Operation
Do not use the equipment
without the hand guard.
Wear suitable clothing and
work gloves when working
with the equipment.
Ensure that the equipment is
functional before each use.
The on/off switch (
A
11) and
the switch lock (
A
10) must
not be locked. They must
switch off the motor when on
is released. Should a switch
be damaged, stop working
with the equipment. Ensure
that the mains voltage value
matches the label on the
equipment.
Note noise protection and local
specifications. The use of the equip
-
ment on certain days (e.g. Sundays
and national holidays), at certain
times of day (lunch times, night time
quiet periods) or in special areas
(e.g. health resorts, clinics etc.) is
restricted or forbidden.
C adjust telescopic arm
The telescopic tube (6) can be adjusted
continuously using the clamp lever (7).
1. Open the clamp lever (7).
2. Hold the device on the handle (8) and
on the telescopic tube (6) and change
the rod length by pushing or pulling.
3. Close the clamp lever (7)