Parkside KH 3145 ELECTRIC TACKER, Инструкции по эксплуатации и безопасности, Страница: 7 / 10

9 GB / IE
a particularly hard substrate. Redriving must be car-
ried out directly at each staple or nail. If you do not
lift the nose
R
when doing this then no further
staple or nail will be loaded into the driving position.
j
Drive the required staple or nail and press the
nose piece
R
once more on to the next redriv-
ing position.
j
Press the trigger
W
as often as necessary until
the staple or nail is flush with the substrate.
Examples of use:
j
Fastening a covering to the seat of a chair
(see Fig. B).
j
Fixing a skirting at the joint between the wall
and floor covering (see Fig. C).
j
Stretching and stapling a canvas to a frame
(see Fig. D).
j
Attaching a protective film to insulation material
when installing thermal insulation (see Fig. E).
j
Attaching fixings for components in a wall
cladding system (see Fig. F).
L
Tool storage
j
If you are not going to use the tool for a while
disconnect the mains lead
O
from the mains.
j
Keep the tool safe from unauthorised use.
j
Keep staples and nails in secure containers.
L
Rectifying faults
m Attention!
J
If you are going to rectify faults disconnect the
mains lead
O
from the mains.
Fault
Cause
Remedy
The tool does not work properly.
A staple or nail is blocking the tool.
Open the magazine slider
U
. This should re-
lease the pretension. Take off the front plate
E
with the hexagonal socket screw key
P
.
Remove the staple or nail.
A staple or nail has been incorrectly driven into
the material.
Remove the incorrectly driven staple or nail with
pincers or pointed pliers.
Select suitable staples or nails.
Set the required impact force that will correctly
drive the staples or nails.
The tool is defective.
Contact the service centre (see guarantee docu-
mentation).
L
Maintenance and cleaning
m Attention!
J
Before carrying out maintenance or cleaning
disconnect the mains lead
O
from the mains
supply.
The electric tacker is designed to be maintenance-free.
j
Clean the tool frequently, ideally after each use
using a dry, fluff-free cloth. Never use water or
cleaning agent.
L
Disposal
The packaging is wholly composed of
environmentally-friendly materials that can
be disposed of at a local recycling centre.
Do not dispose of electrical tools with
the household rubbish !
In accordance with European Directive 2002 / 96 / EC
about waste electrical and electronic equipment and
its transposition into national legislation, worn out
electric tools must be collected separately and taken
for environmentally compatible recycling.
Contact your local refuse disposal authority for more
details of how to dispose of your worn out electrical
tools.
Operation / Rectifying faults / Maintenance and cleaning / Disposal