Parkside KH 3145 ELECTRIC TACKER, Инструкции по эксплуатации и безопасности, Страница: 6 / 10

8 GB / IE
J
Protect your eyes. Wear protective glass-
es. This also applies to people who
may be helping with the work by supporting or
holding the workpiece.
J
Before you start to use the tool, check that it is
in perfect condition.
J
Make sure the tool is switched off before you
load the magazine
T
. To do this set the On / off
switch
I
to position “O”.
To work safely!
J
Before undertaking any type of work with the tacker
make sure that materials and workpieces are safely
held in position. If necessary have a second per-
son on hand to support or hold the items steady.
J
Protect the tool from moisture.
J
Do not use the tool on moist or wet materials.
J
If you have finished using the tool or are taking
a prolonged break from your work disconnect
the mains lead
O
from the mains.
L
Operation
L
Loading the magazine
Use only fine wire staples (type 53), narrow-backed
staples (type 55) or nails (type 47) !
j
Press the magazine slider
U
in the direction of
the magazine
T
and guide it upwards.
j
Pull the magazine slider
U
completely out of
the magazine
T
.
j
If necessary remove any staples or nails of the
wrong type from the magazine
T
.
j
Slide the correct staples or nails into the maga-
zine
T
.
j
Look at the depiction on the magazine slider
U
for how to insert the staples or nails correctly.
j
Push the magazine slider
U
into the magazine
T
until it meets the stop.
j
Then press the magazine slider
U
downwards
until it has definitely engaged.
L
Setting the impact force
A tip!
j
Select the lowest impact force required for stapling.
j
You can set the impact force at any value be-
tween “1” (lowest impact force) and “7” (high-
est impact force) using the impact force
controller
Y
.
L
Switching on and off
m Attention!
J
Connect the tool to the mains only when it is
switched off. To do this set the On / off switch
O
to position “O”.
To switch on
j
Set the On / off switch
I
to position “1” (see Fig. A).
To switch off
j
Set the On / off switch
I
to position “O”.
m Blow count:
The Electric Tacker PET 23 VARIO is designed for
30 blows per minute.
m Continuous Operating Time:
The Electric Tacker PET 23 VARIO is designed for
15 minutes of continuous operation at the maximum
blow count. Allow the appliance to cool down suffi-
ciently after such a tasking.
L
Stapling
j
Switch on the tool.
j
Press the nose
R
on the spot where you wish
to staple.
j
Press the trigger
W
.
j
Adjust the impact force to suit the materials,
staples or nails.
Redriving:
Use this function if you discover that some already-
driven staples or nails have not ended up flush in
Safety / Operation