Parkside HG07773A, Инструкции по эксплуатации и безопасности

Страница: 15 / 102

15 GB
Measuring the depth of a drill hole
4. Remove the depth measuring tip
[ 7]
from the
depth measuring tip holder
[ 6]
. Insert the depth
measuring tip into the back at the lower end of
the scale
[ 1]
.
5. Slide down the product to the lower end of the
scale
[ 1]
.
6. Select the desired measurement mode with the
measuring mode toggle button
[ 5]
.
7. Perform the measurements.
8. Read the measuring values on the LC
display
[ 10]
(Fig. D).
9. Switch off the product: Press and hold the on/
off button
[ 9]
for approx. 2 seconds.
˜
Switch the measuring mode
NOTES:
ABS mode: The displayed measuring value
is the absolute value. The reading is set to 0
when pressing the on/off button
[ 9]
.
When measurement mode is switched from
ABS
to
INC
, the displayed value is set to
0
.
The displayed measuring value is the relative
value (Fig. E).
Briefly press the measuring mode toggle
button
[ 5]
to select the desired measurement
mode ABS or INC . The selected mode is
indicated on the LC display
[ 10]
.