Parkside 345144 2004, Перевод оригинальной инструкции по эксплуатации и безопасности

Страница: 26 / 125

26 GB/IE
Safety instructions
„
Prior to each use, check that
it is working properly by
pressing the “Test” button.
„
The product is not suitable for
laser welding.
„
The product is only approved
for use within a temperature
range of between -5 °C to
+55 °C.
„
The product is not fire-resistant.
„
Welding helmet and UV filter
must not be exposed to any
heat or moisture.
„
Do not remove the ADF filter
from the welding helmet and
never open the housing of the
ADF filter without authorisation
from the manufacturer.
„
Prior to each use, check
whether the Welding/Grinding
setting was selected correctly.
„
The viewing pane must be
installed on the outer side of
the ADF filter. Otherwise, the
ADF filter can get damaged.
„
Do not carry out any modifi-
cations/replacements on the
welding helmet and ADF filter
without consent.
„
If the filter does not darken
automatically whilst welding
please stop the operation
immediately and contact the
dealers without delay.
„
Do not use any alcohol, fuel
or diluting agents to clean the
ADF filter. Do not place the
ADF filter in water.
„
The response time of the ADF
liquid crystal slows down if the
ambient temperature is lower,
however this does not have
an impact on the protective
functions.
„
Please replace the housing
of the ADF filter immediately
if it is damaged or scratched
because this can impair
visibility and the protective
performance.
„
Please replace the viewing
pane immediately if it is bro-
ken or scratched. Do not use
any hard objects to replace the
viewing pane of the filter.
„
Regularly clean the surfaces
of the ADF filter, sensor and
solar cells.
„
The welding helmet cannot
withstand any damages that
are caused by a heavy blow,
explosion or abrasive liquids.
„
The useful life depends on
many different individual
factors such as usage, clean-
ing, storage and maintenance.
Regular inspections and
replacement in the case of
damage are recommended.
„
The material used to manufac-
ture the product will age
over time. This can result in