Parkside Performance 413752 2201, Перевод оригинальной инструкции

Страница: 57 / 78

PSSAP 2028 A1
■ 50 │
GB
│
MT
Fitting/changing the saw blade
WARNING!
►
Remove the battery before carrying out
any work on the power tool (e.g. mainte-
nance, changing tools, etc.) as well as during
the transport and storage of the power tool.
Unintentional activation of the ON/OFF
switch can result in injury.
♦ Turn the quick-release chuck as far as the
stop and hold it in this position.
♦ Push the required saw blade into the
quick-release chuck as far as the stop.
CAUTION!
► The teeth of the saw blade must point
downwards!
♦ Let go of the quick-release chuck so that it
returns to its initial position. The saw blade
is now locked.
Adjusting the footplate
RISK OF INJURY!
► Always switch the appliance off and remove
the battery before carrying out any work on
the appliance.
♦ Adjust the footplate according to the cutting
depth.
♦ To do so, undo the locking lever and move
the footplate to the corresponding position.
♦ Lock this position by closing the locking lever .
Use
Switching on and off
Switching on
♦ First press the safety lock-out and then the
ON/OFF switch . Afterwards, release the
safety lock-out .
Switching off
♦ Release the ON/OFF switch .
Adjusting the rotational speed
Press the ON/OFF switch lightly for a low
speed. Increasing the pressure increases the speed.
NOTE
► The integrated motor brake ensures rapid
stoppage.
2-speed gearbox
CAUTION!
► You can only press button for the 1st and
2nd gear stage when the device is at a stand-
still.
♦ Press button to shift from 1st to 2nd gear.
Guiding the sabre blade safely
To adapt to the workpiece and for safe placement,
the footplate can be swivelled. It must always be
in contact with the workpiece when the appliance
is running.
Practical advice on sawing
♦ Check the material to be worked to make sure
that all foreign objects have been removed,
e.g. nails, screws, etc.
♦ Ensure that the ventilation slits are not
covered.
♦ Switch the appliance on before moving it
towards the material to be worked.
♦ Switch the appliance off immediately if the saw
blade jams.
Open up the sawn gap using a suitable tool
and pull out the sabre saw.