Parker OSP-P, Руководство по эксплуатации

Страница: 20 / 40

20
Modular Pneumatic Linear Drive System OSP -P / OSPP-BG
Assembly of the Wiper Covers
• Lubricate the felts (49) with the grease for guidance (IDENT-NO. 10550FIL)
• Insert the wipers (48) and the felts (49) into the inner wiper cover (59).
The sealing lip of the wiper must be outwards (see drawing).
• Push the outer wiper cover (51) on the inner wiper cover (50) and slide them
both onto the guide carriage (56).
• Tighten them with the screws (52); see table of the torque on page 19.
Lubrication
The two grease nipples located on both sides of the guide carriage (56) must be filled with grease for the
guiding (IDENT-NO: 10550FIL) until a thin grease film is created by pushing the guide carriage along the
cylinder barrel.
13.4.2 Complete disassembly of the OSPP-BG
Check the position of the parts on the exploded view drawing chap. 17.3 on page 36.
Disassembly of the guide carriage according the description in chap. 13.4.1 on page 19.
Remove end cap
• Remove screws (36) and end caps (35) and remove end caps (35) on both sides.
Remove sealing bands and piston
• Move piston to middle position.
• Pull off two clamp covers (12).
• Remove 2 screws (13) and (15) each for the outer and inner band clamping.
• Remove two clamping pieces (14) for outer sealing band.
• Remove outer sealing band (11).
• Remove two clamping pieces (16) for inner sealing band.
• Pull off two cushioning spigots (20) by inserting screwdriver carefully between cushioning
spigot (20) and cylinder barrel (1).
• Slide the outer wiper cover (51) and the inner wiper cover (50) off the cylinder barrel (1).
• Slide the guide carriage (56) off the cylinder barrel (1).
• Remove the carrier (54) from the piston yoke (27a).
• Push piston and inner sealing band (17) out of cylinder bore (1).
• Pull inner sealing band (17) out of piston.
Remove piston
• Pull off both support rings (25) and remove the keepers (29) and (41) together with the magnet (30).
• Remove slide shoes (28).
• Remove piston seals (24) and cushioning seal (23).
Cleaning and spare part check
• Clean all parts and replace faulty parts.
Only use original spare parts. We recommend to use the spare parts listed in chap. 17.5 on page 37.
• Re-assembly must be carried out on a clean surface.