Parker OSP-P, Руководство по эксплуатации

Страница: 15 / 40

15
EN
10.3 Re-commissioning a linear drive after long periods without operation
• Make two strokes of piston / guide carriage by hand without air pressure.
• Move piston / guide carriage to mid position.
• Continue as for individual linear drives (chap. 10 on page 14).
11 Removal from plant
Crushing hazard and danger of eye injuries.
Be extremely careful when removing OSP-P from the plant.
Observe chapter „2 Safety“ on page 4 and the local safety regulation.
Possible hazards are:
• Residual pressure in lines and adjustment elements
- Slowly depressurise linear drive / plant to remove the residual pressure in the lines and adjustment
elements.
• Heavy parts that might fall down after unscrewing
- Secure heavy parts that might fall down after unscrewing.
- Make sure that there are no persons within the reach of any parts that might fall down.
• Sharp edges
- Wear protective gloves to avoid injuries by cutting.
• Moving the piston / guide carriage
- To avoid uncontrolled movements of the piston / guide carriage depressurise the linear drive / plant.
- In vertical arrangement, move the piston / guide carriage to the bottom final position prior to
depressurisation.
Disposal:
Observe the directives and laws on the disposal of ecologically harmful substances.
Attention, Ø16, 25 and 32:
After loosening the screws of the end cap mounting, screws of the end cap (pos.36) must be checked upon
their correct torque (see table page 24 ) , before pressure is applied.
Pos. 36
Screw for end cap
Torque moments table page 24
Screws of the end cap mounting