Parker MX80S Series, Руководство по эксплуатации продукта

Страница: 31 / 36

MX80S Series Product Manual
31
Parker Hannifin Corporation
EMN Automation - Parker
Irwin, Pennsylvania
Chapter 7 - Maintenance and Lubrication
Materials Required
: Replacement bearing and screw lubrication (See below for lubrication type and
ordering information), clean cloth, small brush
Cross Roller Bearing and Screw Lubrication
Lubrication Type
For positioners with cleanroom preparation R1 , class 1000 compatible (standard): Use
Mobil Vactra Oil No.2 on crossed roller bearings ( J & K )
Kyodo Yushi Multemp PS2 Grease on drive ballscrew ( D6 )
Drive Leadscrews ( D1 , D2 , & D6 ) do not require lubrication
For positioners with cleanroom preparation R2 , class 10 compatible: Use
Castrol Braycote 803 Grease on crossed roller bearings ( J & K ) & on drive ballscrew ( D6 )
Drive Leadscrews ( D1 , D2 , & D6 ) do not require lubrication
Lubricant Grease Appearance
R1 - Translucent - white, smooth and buttery.
R2 - Creamy - white, smooth and buttery
Maintenance Frequency
For both ‘ R1 ’ and ‘ R2 ’ Preparations: Cross roller bearings and drive screws are lubricated at our
facility prior to shipment. For lubrication inspection and supply intervals following shipment, apply
grease/oil every 1000 hours of usage. The time period may change depending on frequency of
use and environment. Inspect for contamination, chips, etc, and replenish according to inspection
results.
Lubricant Application
For both ‘ R1 ’ and ‘ R2 ’ Preparations: Wipe the rails or screw down the entire length with a clean
cloth. Apply lubrication on the rails or screw, using a small brush.
Notes:
Do not use/mix petroleum base grease with synthetic base grease at any time. For lubrication un -
der special conditions consult factory.
Shorter lubrication interval may be required in environments with high amounts of dust and other
contamination.