Parker EME
Introduction
192-510014 N06 April 2013
9
1.5.1.
Special notes on transport
Special notes on transport
Use only transport equipment with sufficient lifting capacity. When using ropes,
make certain they are not twisted or knotted. If you are using more than one rope,
all the ropes should be equally taut.
When transporting the ETH with a forklift, establish a condition of equilibrium and
secure the load if necessary.
Never step under overhead loads - danger of being injured!
Moving parts must always be secured against slipping or moving.
*By wrapping several turns of strong adhesive tape around the sliding carriage, which if possible is in
the centre of the profile, for example.
Note
Danger when transporting long actuators. Because the actuator bends under its own
weight, guiding accuracy may deteriorate significantly. In addition, the shape of the profile
may change and the travel behavior of the (sliding) carriage may be negatively affected.
Additional information on transport:
(see on page 8)
In general no means of transport are needed for the LCB. The linear actuator can
be carried, depending on the size, by one or two persons.
