Storing the dryer
18
HDK-CNG_EN_03_2016
Anchoring the dryer
The upright stand profiles of the dryer are provided with pre-drilled anchorage
bores.
► Use suitable attachment material to anchor the dryer to the floor.
►
In the case of vibrating floors
: place the dryer on suitable vibration dampers.
Storing the dryer
If the dryer is to be stored for an extended period of time, the storage location
must meet the following conditions:
The dryer must not be stored in the open air.
The storage room must be dry.
The storage room must be free from dust or the dryer must be covered by a
protective sheet.
The storage room must have an ambient temperature of at least +1 °C
(33,8 °F).
In order to store the dryer proceed as follows:
► Take dryer out of operation as described on page 39.
► Ensure that the natural gas inlet and outlet valves installed by the operator
are closed, and that the dryer is depressurised.
► Disconnect dryer from the natural gas network.
► Disconnect the dryer from the electrical power supply and all external lines.
► Using plastic film or a similar material, seal the natural gas inlet and outlet
apertures on the dryer to protect the dryer against the ingress of dirt
► If possible cover dryer with a protective sheet.
The dryer can now be stored for long periods.
Note:
If you wish to take the dryer back into service after an extended period
of storage, please proceed as described for its first commissioning and
start-up.
Store drying agents
► Do not store drying agents in the open air.
► Protect drying agents against humidity.
