Easy Start Guide
9. How to switch from Local (keypad) control to
Remote (terminal) control and back
Page 11
This guide has been produced by The Inverter Drive Supermarket Ltd.
All content, including but not limited to graphics, text and procedures copyright
The Inverter
Drive Supermarket and must not be reproduced or altered without prior written permission.
©
9.1 Press and hold the stop button.
When the drive is in Local control mode a small hand
symbol is shown on the right side of the display.
Press and hold the stop button to switch the Inverter from
Local control via the keypad to Remote control via the IO
terminals.
Keep the stop button held down.
9.3 The display shows “rdy”.
If the display immediately switches back to local
control (ie. the hand symbol is still visible) a run signal
is present. Check the IO terminals and disable the run
signal before attempting this procedure again.
Once the process is complete the display shows “rdy”
(ready) and the stop button can be released.
Parker SSD Drives 650 Series Inverter
9.2 “LOC” is displayed.
The display shows “LOC” and each letter disappears one at
a time whilst the Inverter switches to remote control.
Keep the stop button held down.
9.4 To switch back to Local control.
Press and hold the stop button as before to switch back to
local control. The display will show “LOC” with each letter
appearing in sequence as the Inverter switches to local
control. Keep the stop button held down.
Once the process is complete a hand symbol appears on
the right side of the display. The stop button can now be
released.
