PARKEN ENG. EQ. CO. P/L
Preparation
1
With roll grinder mounted at correct center height align contact
wheel parallel with work roll.
2
Air must be supplied to belt tension cylinder to enable pressure
switch
1.
Dressing of contact wheel
a.
Grind a work roll approx. 200 mm long
b.
Fasten a piece of 80 grit silicon carbide abrasive to ground
surface.
c.
Switch on contact wheel at
maximum
speed
d.
With work piece
locked
in place feed contact wheel over
abrasive and take light cut to clean up contact wheel.
e.
Carefully dress outside edges of contact wheel lightly
PARKEN
ENGINEERING EQ. CO. P/L
8/15
127var3mf.doc12/15/11
