Park Air T6M, Руководство пользователя, Страница: 25 / 70

PROGRAMMABLE OPTIONS
A number of options can be programmed into the radio's personality. The options are detailed in the
following paragraphs.
Display Blanking
Display blanking is applicable only to Normal and Priority modes; not Scan mode.
When display blanking is programmed, the radio's normal frequency display is replaced by a flashing bar
if the radio is not keyed during the display blanking time period (between 10 and 300 seconds).
Example,
Display blanking is programmed
Display blanking time is 60 seconds
Selected channel frequency is 121.500 MHz.
In this example, the display normally shows 121.500. If the transmitter is not keyed for
60 seconds, the display changes to a flashing bar.
Normal frequency display is reinstated when the radio is keyed, or when the VOL
▲
or VOL
▼
button is pressed. Note that the display can be reinstated by pressing any other button, but
doing so may also alter other settings.
Warning Beeps
When programmed, the following conditions cause a warning beep to be heard when an attempt is made
to key the transmitter:
q
The radio has a fault that prevents transmissions.
q
Trying to key the radio on a channel frequency that has the ‘Transmit Inhibit’ option set to ‘Always
Inhibit’.
q
Trying to key the radio on a busy channel that has the ‘Inhibit if Busy’ option selected.
q
Imminent transmitter time out.
The volume of warning beeps is set in the personality (a value between 1 and 7); the front panel volume
control does not affect the beeps.
Key Beeps
This option, when programmed, produces a single beep whenever a button is pressed on the radio's
front panel. The volume of the beep is the same as the Warning beep.
T6M Base Station User Guide
Page 25