Installation Sheet and Users Guide
FCC Compliance Information
Federal Communications Commission
Compliance Information Statement (FCC Rules Section 2.1077)
2.1077 (a) (1) Product identification
Name: StormPort 610 Modem, Product code: 02-00071-01A
2.1007 (C) The compliance information statement shall be included
in the user guide or as a separate sheet.
FCC Part 15 Statement
Note: This equipment has been tested and found to comply with the limits for a Class
A digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This eq
uipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment
in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.
CISPR 22 Statement
Warning:
This is a Class A
product. In a domestic environment this product may cause interference in which case the user may be required to take adequate measures
.
Customer Instructions
The Phone Filters comply with part 68 of the FCC Rules. On the back of this equipment is a designator that contains the FCC registration number and ringer equivalence for this equipment. If requested,
this information must be provided to the telephone company. The equipment uses the following standard connections and codes: USOC-RJ-11.
The Phone Filters also comply with part 1950 of the UL certifications, and part 22.2 of the CSA certifications.
The Ringer Equivalence Number (REN) shown on the filter is used to determine the quantity of devices which may be connected to the telephone line. Excessive RENs on the telephone line may result in
another device not ringing in response to an incoming call. The sum of the RENs should not exceed (5). To be certain of the number of devices that may be connected to a line, as determined by the total RENs,
contact the local telephone company.
If the equipment causes harm to the telephone network, the telephone company will notify you in advance that temporary discontinuance of service may be required. But if advance notice is not practical, the
telephone company will notify the customer as soon as possible. Also, you will be advised of your right to file a complaint with the FCC if you believe it is necessary.
The telephone company may make changes in its facilities, equipment, operations or procedures that could affect the operation of the equipment. If this happens the telephone company will provide advance
notice in order for you to make necessary modifications to maintain uninterrupted service.
If the equipment is causing harm to the telephone network, the telephone company may request that you disconnect the equipment until the problem is resolved.
The equipment can not be used on public coin phone service provided by the telephone company. Connection to party lines is subject to state tariffs. (contact the state public utility commission, public service
commission or corporation commission for information).
No repairs can be performed by the user. If you experience trouble with this equipment and/or for repair and warranty information, please contact distributor technical support.
2.1077 (a) (2) Compliance Statement
This device complies with part 15 of the FCC rules. Operation is subject
to the following two conditions:
a. This device may not cause harmful interference, and
b. This device must accept any interference receive, including interference
that may cause undesired operation.
2.1077 (a) (3) Responsible Party (FCC 2.909)
Paradyne Corporation
8545 126th Avenue
Largo, FL 33773
Phone: 727-530-2000
www.paradyne.com
Power LED
This LED is green when the modem is receiving power.
Transfer LED
When the LED is flashing yellow, it is “training” (communicating
with equipment at the ISP), and the LED will change to green when this
process has completed. The LED will stay off if the modem
is unable to "train" with the ISP equipment. Under normal operation,
this LED flashes green when the modem is transferring data to and from
the Internet.
610-A2-GN70-00
Ethernet Port
Important Safety Information
When using the StormPort Modem, exercise the following
safety precautions to guarantee safe and efficient operation
of your modem:
1) Do not use this modem near water such as near a bath
tub, kitchen sink, wet basement or swimming pool.
2) Do not use the telephone connected to this modem during
an electrical storm in order to avoid the risk of shock from
lightning.
Note: While this modem meets stringent telecommunication
industry standards for current and voltage surges, the
warranty does not cover failures caused by lightning.
DSL Modem
S T R M P O R T
TM
Copyright 2002 Paradyne Corporation. All Rights Reserved.
C
610-A2-GN70-00
