Paradyne HOTWIRE 8610 DSLAM, Руководство по установке

Страница: 19 / 56

2. Installation
8610-A2-GN20-10 April 2001
2-3
Unpacking the Hardware
When shipped, the Hotwire 8610 DSLAM chassis is packed in a cardboard
shipping container. Carefully remove the 8610 chassis from its shipping container
and check for physical damage. If the 8610 chassis shows signs of shipping
damage, report this immediately to your shipping and sales representatives.
Package Contents
The Hotwire 8610 DSLAM chassis, as shipped, consists of the following:
„
Three filler plates installed in Slots 1, 2, and 3.
„
AC power cord (if your chassis has the AC power option)
„
Two reversible mounting brackets (for 19- and 23-inch rack mounting)
„
Associated hardware bundled in a plastic bag:
— Four #10-32 mounting screws
— Four #12-24 mounting screws and four #12-24 Speed Nuts (for use with
racks without threaded mounting holes)
— Four #8-32 Phillips pan-head screws for center mounting
— Three #4-40 Phillips pan-head screws (to replace longer Telco captive
screws when using the rear-mounted connectors)
NOTE:
The Hotwire 8610 DSLAM chassis requires an MCP card and at least one
DSL card for proper functionality. These cards are not
provided as part of the
8610 chassis and must be ordered separately.
Be sure to register your warranty at www.paradyne.com/warranty.