ACCULINK 336x E1 NTU
4-6
June 1996
3360-A2-GB20-10
Performance Reports
Network performance is continuously monitored and
maintained in network registers (NET), in G.703 DTE
registers (DTE) and, if configured to do so, in far-end and
near-end port registers (Prtn, where n is 1, 2, 3, or 4).
Registers shown on the front panel LCD are listed in
Table 4-4.
NET and DTE registers are status registers that collect
performance data for the previous 24-hour period.
Performance data is updated in 15-minute intervals. After
15 minutes, the current interval is rolled over into a set of
accumulator registers that represent the previous 96
15-minute intervals for the register. An interval total of
how many of the 96 registers contain valid data is also
kept, as well as a 24-hour total for each accumulator
register.
For 2-port and 4-port E1 NTUs, port performance is
continuously monitored and maintained in memory
registers when the port is configured to use EDL. The
E1 NTU maintains two sets of port registers for each
synchronous data port: far-end port registers and near-end
port registers. These registers are status registers that
collect performance data for the previous 8-hour period.
Port data is updated in 15-minute intervals. After
15 minutes, the current interval is rolled over into a set of
accumulator registers that represent the previous 32
15-minute intervals for the register. An interval total of
how many of the 32 registers contain valid data is also
kept, as well as a 8-hour total for each accumulator
register.
NOTE
The following procedure is an
example only. Screen displays
may vary depending on the
model and configuration of the
E1 NTU. The procedure for
displaying DTE and port registers
is similar to this example.
To display network (NET) performance,
1. From the top-level menu screen, select Stat.
F1
E1 HDSL NTU
Stat
Test
Cnfig
F2
F3
2. From the Status screen, press the
key until the
Perf selection appears on the screen.
3. From the Status screen, select Perf.
F1
Status:
DevHS STest
Perf
F2
F3
4. Select NET registers.
F1
Performance:
NET
DTE
Prt1
F2
F3
5. From the NET Registers screen, select E1 to view
the registers that apply to the E1 (G.704) network
interface. Select Lp1 or Lp2 to view the HDSL
loop 1 or loop 2 network interface registers. (In
the following example, E1 is selected.)
F1
NET Registers:
E1
Lp1
Lp2
F2
F3
6. From the E1 Registers screen, press F1 to view
current registers (go to Step 7), press F2 to view
24-Hour Totals (go to Step 8), or press F3 to view
15-Minute Interval Registers (go to Step 9).
F1
E1 Registers:
Cur
24Tot
Intvl
F2
F3
