Paradox Spectra 1759EX V1.0, Справочное и монтажное руководство

Страница: 14 / 60

12
R
EFERENCE
& I
NSTALLATION
M
ANUAL
Figure 3.1: Data Display Mode (LED Keypads Only)
3.3 CONFIGURING THE LED KEYPADS
Depending on the version of the keypad, two methods can be used to configure the LED keypads (1686H, 1686V and 1689):
3.3.1 C
ONFIGURING THE
1686H, 1686V
AND
1689 K
EYPADS
V2.0
OR HIGHER
The keypad’s zone number, EOL definition and tamper switch are programmed through the control panel’s
programming mode. To do so:
PLEASE NOTE: After two minutes, the keypad exits programming mode.
Key [1] - Keypad Zone Selection
Key [1] determines whether the keypad’s zone is Keypad Zone 1 or Keypad Zone 2. When key [1] is OFF (not
illuminated), the keypad’s zone is Keypad Zone 1. When key [1] is ON (illuminated), the keypad’s zone is Keypad Zone 2.
Key [1] OFF - Keypad Zone 1 (default)
Key [1] ON - Keypad Zone 2
Key [2] - EOL Definition
Key [2] determines the keypad zone’s EOL definition. When key [2] is OFF (not illuminated), EOL is disabled and the
keypad zone will use the on-board EOL resistor. When key [2] is ON (illuminated), EOL is enabled and the keypad
zone requires that an external EOL resistor be connected (refer to Spectra 1759EX Control Panel Overview on page 7
for more details).
Key [2] OFF - EOL disabled
Key [2] ON - EOL enabled (default)
Key [3] - On-Board Tamper
Key [3] enables or disables the keypad’s on-board tamper switch. When key [3] is OFF (not illuminated), the tamper
switch is disabled. When key [3] is ON (illuminated), the tamper switch is enabled.
Key [3] OFF - On-board tamper switch disabled
Key [3] ON - On-board tamper switch enabled
How Do I Configure The Keypad?
STEP 1: Press [
ENTER
]
STEP 2: Enter your [
INSTALLER CODE
] (default: 000000)
STEP 3: Press the [
PG
] (1686H/V) / [
FNC
1] (1689) key and hold it for 3 seconds.
STEP 4: Press the desired key ([1] to [3]. See below)
STEP 5: Press [
ENTER
] to exit programming mode
To access the Data Display Mode, press the [enter] key after entering a section and before entering any data. The three LEDs as indicated will begin
to flash indicating that you are in the Data Display Mode.
Each time the [
ENTER
] key is pressed, the keypad will display the next digit in the current section and will continue through all the following sections
one digit at a time without changing the programmed values. Not available for sections using the Multiple Feature Select Method. Press the [
CLEAR
]
key at any time to exit the Data Display Mode.
1686H
1686V 1689