Paradox NV780MR Скачать руководство пользователя страница 1

NV780MR

Installation Manual V1.0

Wireless Dual Side-View

Anti-Mask Outdoor

Detector

General Description

The 

NV780MR is a wireless dual, independent, side-by-side view 

Passive Infrared (PIR) motion detector with dual anti-mask in a 
single housing, providing boundary protection. Covering 
approximately 24m / 78 ft. (12m / 39 ft. on each side) and 
configurable to report either as a single unit with two sides 
reporting as a single zone output or as a dual unit with each side 
reporting as a separate zone input.

Installing the NV780MR 

 Figure 1 : Front View - Open Cover

Minimum Recommended Installation Distance

: At least 40 cm/

15.7 in. from the protected area (door, window, etc.) 

Anti-Mask Calibration

The anti-mask will only calibrate after the tamper is closed. The 
NV780MR performs anti-mask calibration for up to 40 seconds, 
indicated by flashing red / green LEDs until completed. On 
completion, the LEDs shut off. If the buzzer is set to ON, three 
beeps signal that calibration is complete. 
IMPORTANT: During calibration, no objects should be within 2m /
6 ft. of the anti-mask field of view (on both sides of the detector).

Dip Switch Settings

Table 1

Power-Up Sequence Indication

• LED: Both left and right LEDs blink red for five seconds.
• Buzzer Switch ON:

• Single Mode: One tone beeping for five seconds.
• Dual mode: Alternate tone beeping for five seconds.

• Anti-mask calibration can take up to 40 seconds, red / green 

flashing if Buzzer is ON; three beeps indicates completion.

Alarm

• LED: Red LED indication on the relevant side(s) for three 

seconds.

• Buzzer Switch ON:

• Single Mode: Same tone for either side detection.
• Dual mode: Each side has its own tone.

Anti-Mask Detection

• LED: Flashes orange rapidly (pre-alarm state) and then 

flashes when in alarm.

• If Buzzer is ON: buzzer beeps for 3 seconds.

NOTE: 

The anti-mask relay is open during anti-mask detection.

Beam Patterns

Beam Range Adjustment

Horizontal Beam Adjustment

Anti-Mask

Screw Holes x6

Dip Switch

Wire Entry

Jumper

(see Table 1)

DIP SWITCH

OFF

ON (DEFAULT)

1. RF MHz

868

433

2. BUZZER

OFF

ON

3. SENSITIVITY

LOW

HIGH

4. ZONE

DUAL

SINGLE

JUMPER: LED

OFF

ON

0

20°

12m

40 ft

3m

10 ft

3m

10 ft

12m

40 ft

20°

3m

f

60

 

cm 

0

12m

40 ft

12m

40 ft

30 cm (12 in.)

Отзывы: