MSA4H/V: 4 Button Wall Switch V1.0
Overview
1) Output and macro control buttons
2) Button lights
3) Button label window and label lights
4) Multibus feedback LEDs
5) Label trays
6) 4-wire Multibus connection
Wiring
Connecting an MSA4H/V
LED Feedback
Description
The MSA4H/V is designed to work with the Imperial system’s
MAMA home automation engine. Each button can be
programmed to control a single output, multiple outputs, or
macros. The wall switch can provide on/off control of lights,
sprinklers or macros, set lights to a fixed dimming level, or
open motorized shutters to a preset height.
All wall switches are driven by the V32 Main Controller’s 4 wire
low-voltage Multibus. This means that the high voltage wiring is
not connected directly to the switch as in regular electrical
systems. Since the wall switches use low-voltage bus
communication, they can be installed anywhere including wet
areas or outdoors (avoiding direct sunlight, or exposure to rain/
snow).
Up to 510 wall switches can be programmed to control one
output, as opposed to a maximum of 3 switches or 1
dimmer knob in regular electrical systems.
Features
•
4 buttons to control outputs (lights, sprinklers, shutters,
etc.) or macros (group of outputs)
•
Multiple switches can control the same output (max. 510)
•
Custom designer colours available
•
Set in Toggle mode (1 button on/off) or Switch mode (1
button on / 1 button off)
•
Adjustable Day/Night LED brightness
•
Remote firmware upgrade via Multibus using RS485 at
57.6Kbps
•
All programming is done using BabyWare PC Software
•
Bi-directional Module Locate feature
•
Connects to Multibus: 4-wire encrypted 13.8 VDC
•
communication bus
•
Single gang box installation (for dimensions, refer to
Specifications
)
TM
MSA4H (horizontal)
MSA4V (vertical)
NOTE:
For more detailed installation and programming
instructions, refer to the Imperial System Guide.
1
6
2
5
3
4
Specifications
Multibus rating
13.8 VDC Class 2; 35 mA
Dimensions
7.4 X 11 X 2.5 cm (2.9 X 4.3 X 1 in.)
Operating
temperature
-10ºC to 50ºC
(14ºF to 122ºF)
Imperial
Multibus
WARNING:
To avoid damage when
installing and servicing, observe
proper ESD precautions.
NOTE:
Wiring methods must be in
accordance with the National Electrical
Code ANSI/NFPA 70.
= Off
R = Red G = Green B = Blue
= On
= Flashing
MULTIBUS
OK: Communication in
progress
Com fail: GRN/YEL reversed
Bus power too low
Module Locate mode
G
G
BUS
RX
TX
G
G
RX
TX
BUS
R
BUS
RX
TX
R
Com fail: GRN/YEL short /
no data / Multibus in
RS485 mode
BUS
RX
TX
R
G
RX
TX
BUS
R
Com fail: too many
modules / wrong data
G
G
RX
TX
BUS
R
Firmware upgrade in
progress
Button 1
LED
Rapid flash
NOTE:
“BUS” LED may be labeled “ERR” on some hardware versions.
BUTTONS
Press to activate/deactivate the button’s
associated output or action (refer to
Programming an MSA4H/V Wall Switch
in the Imperial System Guide).
Button activated
Button deactivated
R