Paradox Esprit E55, Руководство по программированию

Страница: 4 / 48

2 Programming Guide
Entering Programming Mode
1. Press [
ENTER
] .
2. Enter your [
INSTALLER CODE
] (default: 000000) or [
MAINTENANCE CODE
] (no default). [
ARM
] and [
STAY
] lights flash.
To modify codes, see System Codes on page 31.
3. Enter 3-digit [
SECTION
] you wish to program. [
ARM
] and [
STAY
] lights are ON.
4. Enter required [
DATA
] .
WARNING: StayD Mode must be deactivated in order to enter programming mode. To deactivate StayD, press [
OFF
] + [
CODE
] +
[
OFF
].
Data Entry & Display
There are two methods that can be used to enter data when in programming mode: Single Digit Data Entry and Feature Select
Programming methods:
Single Digit Data Entry Method
After entering programming mode, some sections will require that you enter decimal values from 000 to 255. Other sections will require
that you enter hexadecimal values from 0 to F. The required data will be clearly indicated in this manual. When entering the final digit in a
section, the panel will automatically save and advance to the next section.
Feature Select Programming Method
After entering certain sections, eight options will be displayed where each option from [1] to [8] represents a specific feature. Press the
key corresponding to the desired option. This means the option is ON. Press the key again to remove the digit, thereby, turning OFF the
option. Press the
[
CLEAR
] key to set all eight options to OFF. When the options are set, press the [
ENTER
] key to save and advance to the
next section.
Important Settings and Modes
Section Description
[950] Reset all programmable sections to factory default values
[955] Clear bus module trouble (remove disconnected module from the bus)
[970] Download memory key into panel (see the Reference & Installation Manual)
[975] Upload panel into the memory key (see the Reference & Installation Manual)
[980] Display version number of the panel (see Viewing Version Numbers on page 3)
To access the Data Display Mode, press the [
ENTER
] key after entering a section and before entering any data.
The three keys / four LEDs as indicated below will begin to flash indicating that you are in the Data Display Mode.
Each time the [
ENTER
] key is pressed, the keypad will display the next digit in the current section and will continue through all the
following sections one digit at a time without changing the programmed values. Not available for sections using the Multiple Feature
Select Method. Press the
[
CLEAR
] key at any time to exit the Data Display Mode.
K636 K10V/H
K32I
K32