Papendorf SOL.Connect Center III, Руководство пользователя, Страница: 108 / 129

108
Set-up Messaging
8 Set-up Messaging
You can configure and send individually customized notifications.
To send messages the following steps must be followed:
•
Set-up e-mail service.
•
Set-up message recipient.
•
Allocate messages to a recipient.
•
Determine recipients in monitoring groups and / or analysis groups.
E-mails which could not be sent due, e.g. caused by an erroneous e-mail ad-
dress will be recorded in the system messages. It is advised to sort these out
immediately!
In case several people shall be informed at the same time it is recommended
to use just one single message recipient as distributing address (e.g.
sup-
port@sampleaddress.com ).
Should you - despite correct configuration - not receive e-mails
please check your spam filter.
In addition please check regularly the sending e-mail account be-
cause in most cases of problems a message is being returned.
On exclusive use of a modem sending e-mails is only possible with
an active internet connection (dial-out switch), see also chapter 4.